Mapco HPS - high performance standard. Do you have questions about the product? Horizontal handlebar handlebar arm set MAPCO HPS reinforced A6 4F front axle front for Audi. 1 x cross bar bottom right.1 x wishbone lower left rear. 1 x wishbone lower right rear. 1 x wishbone top left. 1 x wishbone top right. 1 x Wishbone upper left rear. 1 x upper wishbone rear right. 1 x tie rod end outside left. 1 x tie rod end outside right.
1 x stabilizer / coupling rod on the left. 1 x stabilizer / coupling rod on the right. 1 x set of fixing screws with nuts.
OE numbers (are for comparison purposes only). Vehicle spare parts from MAPCO Autotechnik are produced with the same specifications as the original parts from the corresponding vehicle manufacturers. In some cases, however, the quality can be significantly improved by our own engineers, and so a standard product becomes an innovative MAPCO high performance standard product (HPS). The MAPCO HPS products far outperform the original parts in terms of quality, and they are extremely durable. The HPS stabilizer struts are made from 12 mm round steel.
The MAPCO-HPS product thus has a higher resistance to bending, which extends the life of the ball joints. HPS products from MAPCO are technically innovative and wear-resistant.
In addition, we use only semi-synthetic greases for permanently lubricated ball joints in our articles, such as anti-roll bars, tie rod ends, handlebar arms, wheel suspension repair kits, suspension joints, which offer high corrosion protection and greatly reduce slip-back. We use joint balls with a mirror-smooth surface in all joints of the mentioned articles. The term "mirror" is law.
This reduces wear and tear and increases the service life of the joints. Furthermore, this processing leads to short break-in times. Special cuffs, which are predominantly installed transparently in our HPS products, increase the temperature range and improve the durability of the cuffs. Awarded and certified by the TÜV The HP technology is certified by the TÜV Rheinland. In extensive testing procedures, function-related quality characteristics were tested elaborately.
Special attention was on the strength of the material used, the resistance to environmental influences and the wear and tear tests the tests. After very good cutting of HPS products in all areas, they have been certified by TÜV Rheinland. Any product received a unique certificate number under the find it on the MAPCO site and of course by the TÜV. Komplett, beste Werkstattqualität, lange Lebensdau. The item "Mapco HPS Arm Set 52-TLG Reinforced for Audi A6 4F-2 H 5 C6+ Allroad+ Avant" is in sale since Friday, August 23, 2019.This item is in the category "Vehicle Parts & Accessories\Car Parts\Suspension & Steering\Control Arms & Parts". The seller is "sportbremsen" and is located in Borkheide. This item can be shipped worldwide.